Prepare CalComp 2500 Series Tablet for Use in Windows 3.x/95/NT

Set Tablet Menu Settings to "AutoCAD as GTCO DP5"  from the 2500 User's Manual

    1.  Refer to the "SETTING THE SOFT SWITCHES" in your 2500 User's Manual for instructions on setting up the
         tablet for "AutoCAD as GTCO WITH GTCO MICRO DIGI-PAD EMULATION."

    2.  Following are the menu settings required to enable your digitizer to operate correctly:

        Bank 1-  00000001             Bank 4-  00110100
        Bank 2-  11001000             Bank 5-  01010100
        Bank 3-  01110111             Bank 6-  00001000

       (1 =  Power Light is  ON  0 = Power Light is  OFF) 
   
     3.  To change the menu settings:
  
         a.  Place the cursor on the "BANK" block.

         b.  Select the block by pressing the "0" button. The indicator light will show which of the 8 banks is currently
              active.

         c.  Select the block whose number corresponds to the number of the bank you wish to set.

         d.  Select the "SETUP" block.  The BANK indicator will go off and the SETUP indicator will go on.  The lights in
              the eight numbered blocks now indicate the status of the switches in that bank. 

         e.  The Pick 0 button will toggle the light of each block to the setting you wish.

         f.  Repeat steps "a" through "e" for each bank requiring changes.

         g.  When finished, EXIT by hitting the "SETUP" box again.